Start your tape measure on one end of the bar and extend the tape to the tip on the other side to find the true length. To find out the true length of your bar, round the measurement to the nearest inch. If you have a bar that is too short or too long, you will need to adjust the length to get the correct measurement.
Table of Contents
What do the numbers on the chainsaw bar mean?
The final set of numbers show how many drive links are in the chainsaw chain that will run on that specific bar. The bar needs a 72 drive link chain because it has “72” stamped on it.
What is bar length for chainsaw?
The most common chainsaw bar size is 12 to 20 inches, but they come in larger sizes for professionals. The heavier the blade, the more expensive it is to buy.
If you’re looking for a bar that will fit in your hand, you’ll want to look for one that’s at least 12 inches in length. If you want a longer bar with a blade that can be used in a variety of ways, go for the larger size.
What is the most common chainsaw chain size?
The diameter of a chain is determined by the number of teeth in the chain. A chain with fewer teeth will have a smaller diameter than one with more teeth. Chain diameter is measured from the center of one tooth to the end of the next tooth, with the last tooth being the longest tooth.
Can I put a different size bar on my chainsaw?
Depending on the bar size, most chainsaws can operate up to three different bar sizes. Guide bars range in size from 14 to over 40 inches and are measured in length from the tip of the bar to the heel. You can check the specifications of your model’s operator’s manual to see what size bars you can run.
Does bar length matter chainsaw?
Typically a chainsaw with a shorter bar around 14” and smaller is enough for property maintenance, trimming, pruning, and cutting down broken tree limbs. The longer bar will make it easier to cut down trees, thick branches, and clean up storm damage. If you have a chain saw, you can also use it to cut down trees that are too large for your chainsaws.
If you don’t have one of these tools, then you will have to use your hands to trim the tree down. You can use a pair of pliers to hold the branches in place while you cut them down, but this is not recommended as it can damage the wood. The best way to do this job is to have someone else do it for you.
What is the best size chainsaw for cutting firewood?
You can cut firewood with a chainsaw because the logs are on the ground. The best chainsaw for this job would be 12 to 16 inches. If you are using a chain saw, make sure that the blade is at least 2 inches longer than the saw blade.
If it is too short, it will not cut the wood properly. Also, if you have a saw that is not adjustable, you may need to adjust the length of the chain to get the best results.
How big of a tree can a 20 inch chainsaw cut?
A good rule of thumb is that the diameter of the trees you cut should be no more than twice the length of the bar on a chainsaw. Effective cutting length is roughly -2 inches of tree diameter, so a 20-inch chainsaw can handle a 36-inch tree.
If you’re cutting a large tree, you’ll want to make sure you have the proper tools for the job. You can also use a hand saw to cut the tree down to size, but it’s a bit more time-consuming, and you won’t be able to use the same blade on both sides of a tree at once.
How do I know my chain size?
Measure the distance between any three consecutive rivets, then divide the result by 2 to determine the pitch. The chain segments are held together by the small pegs andstuds of the rivets. To get your chain size, divide the number in half and measure from the first to the third.
For example, if you have a chain that is 1.5 inches long, and you want to cut it down to 1/2 inch, you would measure from one end of the 1 inch chain (the end closest to you) and the end furthest away from you to find the length. Then you’d multiply that length by two, which would give you the number of chains you need.
