Rub toothpaste onto the jewelry to make it shine again. The toothpaste should be put into any small crevices by moving the brush in a circular motion. Before rinsing it off under cold water, keep scrubbing the jewelry until it starts to shine. Dry the jewelry completely so it doesn’t stick to the bristles of your toothbrush.
Table of Contents
What causes the tarnishing of fake jewelry?
It’s simple – over time, your jewelry comes in contact with moisture, acids, oils and air. The metal in the jewelry causes it to eventually wear out. If you’re not careful, you can end up with a piece of jewelry that’s worn out, cracked, or even corroded. This is why it’s a good idea to keep jewelry in a cool, dry, and well-ventilated area.
Can hydrogen peroxide clean fake jewelry?
Can you use hydrogen peroxide to clean jewelry? Absolutely! Fill a small bowl with hydrogen peroxide—just enough to fully cover the piece you wish to clean. If you can smell the solution, you’re good to go. If not, let it sit for a few minutes and then rinse it off with warm water.
How do you clean blackened jewelry?
Rub the baking soda paste onto the jewelry by mixing two parts baking soda to one part water. The paste needs to be dry to remove the tarnish. You can rinse and dry with a soft cloth or microfiber towel. You can use a hair dryer as well.
Does clear nail polish help fake jewelry?
~Clear nail polish is your friend. You can use clear nail polish to prevent discoloration and chipping on costume/fashion jewelry you can apply a thin coat of clear nail polishes to your nails and let them dry for a few minutes before applying the next coat.
How do you keep fake rings from tarnishing?
If you want to prevent tarnishing on this kind of cheap jewelry, you can either coat the parts of the jewelry that are next to the skin with clear, chip-proof nail polish, spot-paint the piece with clear enamel paint, or spray the whole piece with clear spray paint.
If you want to make sure that your jewelry doesn’t tarnish, it’s a good idea to keep it in a cool, dry place, away from direct sunlight.
How do you fix tarnished jewelry?
For heavier tarnish, mix three parts baking soda with one part water. Attach the paste to the silver with a soft cloth. To get a mirror finish, rinse well and buff to it.
For lighter stains, use a solution of 1/2 to 1 gallon of water and 1 tablespoon of vinegar or lemon juice in a spray bottle. Spray the stained area with the solution and allow it to sit for a few minutes before buffing.
