How To Cut Laminate Flooring Without Chipping? (1-minute Read)

how to cut laminate flooring without chipping

A jigsaw is an all-round tool when it comes to cutting floors. It is best to cut out shapes from your board. It’s possible to place boards around your toilet or pillar. If you want the saw blade to spin before you start cutting, use a fine toothed blade. You don’t want the blade to be spinning while you’re cutting so you can’t see what’s going on.

You can also use the jig to create a template for your cut. This is great if you have a lot of boards and you need to make sure you cut them all the same size. The template can then be used as a guide for cutting your boards.

Do you cut laminate flooring face up or down?

The best technique for cutting your laminate is to cut downwards into it with the décor side facing upwards. The plank is prepared for the next step. This is the most time consuming part of this project. You will need to make sure that you have the right size plank for your door, and that it is not too long or too short.

If you are cutting a long plank, you may want to consider cutting it into two pieces, one for each side. It is also a good idea to measure the length of your plank before you cut it, so you know how long it will be before it needs to be cut down to the size you need it.

What is the best way to cut laminate?

You shouldn’t use a utility knife to cut your sheets. A circular saw and a jigsaw are better for fine tuning. Make sure to follow the instructions and security protocols in order to avoid chipping your formica.

How do you cut already installed laminate flooring?

In fact, you can cut the planks using a table saw, miter saw, circular saw, hand saw or laminate cutter. It is recommended that you use a diamond blade as laminate can be difficult to cut through and may damage another blade. The finished side will be cut with the finished side facing up.

Do I need a special blade to cut laminate?

A thin kerf, 80 to 100 tooth, carbide-tipped blade is most effective for cutting laminates and will last for 1000 sqft before it needs to be replaced. For laminate flooring, it is best to use a blade that is at least 1/4″ thick.

For example, if you are using a 3/8″ blade and you want to keep it sharp for a year, you will need to buy a new blade every 3 years. If you have a 5/16″ or 1-1/2″ thin blade you can use it for as long as you like, but you should replace it every 5 years or so.

Do you cut the tongue off the first row of laminate?

We recommend cutting off the tongue on this first row to avoid any problem with the expansion gap. The second plank should be inserted into the first at an angle pressing the short ends together. The same procedure can be done on the other side of the plank.

Repeat steps 2 and 3 for the next two rows. This time, insert the third plank in the middle of each row, pressing down on the long ends. Continue this process until you have completed the entire row.

Can you cut laminate with a utility knife?

Since all plastic laminates are essentially the same, cutting Formica with a utility knife is identical to cutting most laminates. This method works well for one or two shorter cuts, but is too time consuming and inconsistent to use for more than a few cuts.

If you are using a knife that has a serrated blade, you can use the blade to cut the lamination from the inside of the mold. You will need to be careful not to puncture the plastic, as the serrations will cut through the material. If you use a sharp knife, be sure to keep it sharp and clean.

Rate this post
You May Also Like