If you want to fix a tunneled candle, wrap a piece of aluminum foil around the edges and let it burn. Make sure the foil hangs over the built up wax areas, but leave an opening in the center to burn the candle properly. The wax should melt and even out after a couple of hours. If it doesn’t, you’ll need to re-wax the candle.
Table of Contents
How do you fix a tunneling candle with foil?
Use aluminum foil to fix a candle that has started to tunnel Poke a hole in the middle at least an inch wide so that the flame gets enough oxygen to burn. The heat from the candle can be held in by the aluminum foil. Remove the foil and place the melted wax in a container with a tight fitting lid. Place the lid back on and allow to cool to room temperature.
What causes tunneling in candles?
Sometimes candle tunneling is caused by a candle that isn’t large enough for the size of the candle, but more often it is caused by the timing of the first burn. Since all the wax is being burned at the same time, candle tunneling reduces the burn time for the candle, but it can also reduce the amount of wax that can be used to make the next candle. If you’re burning more wax than you need, you’ll need to reduce your candle size.
If you burn too little wax, it will be difficult to see the flame, and you won’t be able to control the temperature of your flame. The best way to do this is to use a lighter to heat up your wax before you start to burn it. This will allow you to get a better idea of how much you should be burning.
Can I microwave a candle?
It is easy to do in a small space. It’s possible to use a microwave in your kitchen, even if you don’t have a microwave in your office. Microwaves are great for melting wax because they heat up quickly and don’t need to be re-heated. You can use them to melt wax on the stove top, in an oven, or even on a stovetop grill.
They’re also a great way to get wax out of the oven and onto the countertop. If you’re using wax to make candles, it’s a good idea to use wax that’s already melted. This way, you won’t have to wait for it to cool down before you use it.
How do you stop tunneling?
You have to keep an open center in order for the flame to continue to burn. The foil helps keep the wax in place and allows the flame to stay even and continuously radiate heat. If you are using a metal foil, make sure it is at least 1/4″ thick.
Make sure you have a clean, flat surface to work on. This is especially important when working on a hot surface, such as a stovetop or oven, as the heat from the burner can melt the aluminum and cause it to melt.
How do you even out an uneven candle?
When the top layer of wax has melted, simply hold the airflow over the candle and let it cool. If you don’t want to wait for the wax to melt, you can also use a heat gun to heat up a small amount of water in a saucepan.
Once the water is boiling, add the melted wax and stir until it’s completely melted. You can then remove the pan from the heat and allow it to cool for a few minutes before using it again.
How do you fix short wick tunneling candles?
If you want to avoid burning the wicks, you can use a paper towel to soak up the excess wax. If you’re using a double boiler, you may need to add a bit more water to get it to the right consistency. If it’s too runny, add more boiling water until you get the consistency you want.
