Find the middle of the frame and pull the picture wire up gently until you reach a point about 2 inches from the top. Once your wire is mounted on your frame, you want it to hang in this location.
You can use a piece of electrical tape to hold the wire in place, or you can just use your fingers to pull it up. If you don’t want to use the tape, then you will need to cut a hole in the bottom of your picture frame so that the wires can hang from it.
I used a 1/4-20 drill bit to make the hole, but you could also use an X-acto knife or a hacksaw. Now that we have our wires attached to our frame, it’s time to mount it to the wall. Some frames are made to be mounted to a wall, while others are designed to sit on a table or other flat surface.
Table of Contents
How much slack do I need for picture wire?
For larger pieces, closer to 1/4 is best, while smaller pieces can be closer to 1/3. Give the wire a bit of slack and it will form a triangular peak between the two sides. The hanging wire should be at least half way between the bottom and the top of the piece. You’ll need to cut a piece of wire that is about 1-1/2 inches long, and about 3/8 inch wide.
This will be used to connect the pieces to each other. The wire should be about the same length as the length of each piece, but the width should not be more than 1 inch. If you have a lot of wires, you may want to use a wire stripper to make sure they are all the right length.
Make sure that the ends of your wires are not touching, as this will make it easier to tie them together later. I used a pair of needle nose pliers to hold them in place while I was doing this. Be careful not to pull too hard on the end of any wire as you are tying it together. It is a good idea to put a small amount of glue on each wire to keep them from fraying.
How heavy can a picture be to hang on drywall?
The large versions can support up to 20 lbs. For heavier loads, use a flat-mounted hook and anchor. Picture frames up to 20 pounds are the best for non-porous surfaces. Rated 5 out of 5 by HomeDepotCustomer from This is a great product. It is easy to install and works great.
The only thing I would change would be to make it a little bigger. I used it to hang a picture frame on the wall and it was a bit too big for the space.
What kind of wire do you use to hang pictures?
Made from strands of steel that have been twisted together under tension, this picture wire is stronger than braided wire but less flexible. It’s best to hang large frames up to 100 lbs. Cordage is a type of wire that has been woven into the fabric of a garment. The cordage can be used to secure the garment to the body, or to attach it to a belt or other piece of clothing.
Do picture hangers need a stud?
Many people ask us if they need to use a wall stud in order to hang a picture. The best way to hang your pictures is to place them on a flat surface, such as a table or a shelf.
This will allow you to position the picture in a way that is most comfortable for you. If you are hanging a large picture, you may want to consider placing it on top of another large piece of furniture, like a bookshelf, so that you can easily move it around the room.
How do you cut picture wire?
Use diagonal cutting pliers to cut any kind of wire. If you don’t have a choice of tools, use long-nose pliers for small-gauged wire and lineman’s pliers for electrical wire. Make sure the electricity is off when you’re cutting live wire. If you can’t cut the wire yourself, you’ll need to use a wire stripper to remove the insulation from the wires. You can also use an electrician to do this job for you.
