The rating of the circuit breaker controlling the circuit is the main limitation on the number of lights that a single switch can control. Standard lighting with a 15amp breaker can only be controlled by one switch, because each 60- watt bulb draws around 1/2 Amp. If you want to control more than one light at a time, you’ll need to use two switches.
Table of Contents
What is the difference between canned and recessed lighting?
The can has an electrical box in the top of the housing, which protects the light bulb. Canless lights aren’t contained in a can. They are a single unit with a thin housing connected to your lightbulb. Canless light bulbs come in many different shapes and sizes, but they all have the same basic shape: a bulb with an opening at one end.
The bulb is connected to a circuit board, which contains the electronics that control the bulb’s brightness and color temperature. When you turn on a light, the circuit turns on and off a relay that sends a signal to the board. If the relay is not working properly, you will see a flashing light.
This is called a “short circuit,” and it can be dangerous if it happens while you are trying to read a book, watch a movie, or do anything else that requires your eyes to look at something for a long period of time.
Do you need an electrician to install recessed lighting?
You will have to pay up to $400 for the installation of the lighting. It’s best to hire a local professional electrician to tackle this job, at a rate of at least $200 per hour. If you’re looking for a more affordable option, you can also install a ceiling fan in your home.
This is a great way to save money on your electric bill, as you won’t have to pay for electricity to run the fan. You’ll also be able to control the speed and direction of the air flow, which can make a big difference when it comes to cooling a room.
Is it OK to drill through floor joists?
The maximum hole size for a 212 joist is 3-3/4 in., which is plenty big enough for running cable. If you want to make your own, you’ll need a drill press and a 3/8-in. drill bit.
You’ll also need an 8-ft. extension cord, which you can buy at Home Depot or Lowe’s for about $10. If you don’t have one of those handy, use a cordless drill and drill a hole in a piece of plywood.
How close can recessed light be to joist?
A fairly standard light should not be fitted so that any part of its assembly is less than half an inch from anything that could be a fire. A two-inch clearance from anything above the lamp is a good rule of thumb.
How do you run electrical wire through floor joists?
To run cable through a floor that has a cross joist, you have to cut a hole in the wall closest to the cable’s entry point.
If you want to run a cable from a wall to a ceiling, you can use the same method as described above, except that you will need to make sure that the cables are not touching each other.
For example, if you have a 2-foot-long cable running from the ceiling of a 1,000-square-feet home, it would not be possible to use this method if it were to touch any other wall or ceiling.
Can I install recessed lighting myself?
If you have a nearby power source, you can easily install recessed lights by yourself. Bringing in a power source adds time to the project, but can be accomplished by wiring your own circuit board. You can also use a light switch to turn on and off the lights.
This is a great way to add a little color to your project. You can find a variety of light switches on the market, and they all have their pros and cons.
