Sealing terracotta pots for painting is an optional step, and it’s totally up to you if you want to do it. If you’re painting terracotta pots for outdoor use, you should use a clay pot sealer before painting them because it will help prevent the pots from drying out and cracking.
However, you should always seal the pot before you paint it, so you don’t end up with a cracked pot that you can’t fix. This is because clay is porous, which means it can absorb moisture from the air and cause the paint to dry out faster than it would if it were painted directly onto the wall or table.
So, if your painting surface is flat, seal it first. You can also use clay sealers on flat surfaces, but you’ll have to be careful not to over-saturate them with water, as this can cause them to crack and crack into pieces.
Table of Contents
What paint do you use to paint terracotta pots?
the best paint to use on terracotta pots is acrylic paint. You need to make sure that the paint is sealed after you paint it. You can use a damp cloth to wipe off the excess paint. If you don’t want to do that, you can also use an old toothbrush to scrub the surface of the pot.
Should you soak terracotta pots?
The number one rule of thumb when using terracotta pots is to soak them prior to use them!. The pots are made out of clay so they will not steal your stones.
Does Mod Podge seal terracotta pots?
Clean clay pots are the start of Mod Podge Terracotta Pots tips. A shiney hard finish can be achieved with gloss Mod Podge. Seal the inside of the pot as a final coat to prevent water seeping in. Clean the outside of your clay pot with a damp cloth. This will help prevent the clay from sticking to the surface. You can also use a toothbrush to scrub off the excess clay.
If you don’t have a brush, you can use the back of a wooden spoon to scrape off a small amount of clay with your fingers. Use a sharp knife to cut a hole in the bottom of each pot. Make sure the hole is large enough to allow the water to drain out, but not so large as to block the drainage hole. The hole should be at least 1/2 inch in diameter and 3/4 inch deep.
Be sure to leave enough room for the drain hole to pass through the top of one pot and into the other pot, so that water can drain from both pots at the same time! Place the pots on a flat surface and fill them with water. Allow them to soak for about 10 minutes, or until they are completely saturated.
Will rain wash away acrylic paint?
The rain will ruin the paint since it is not waterproof. If you have not treated the surface in any way and the paint is still wet, you will need to apply a thin layer of clear coat over the entire surface.
Can you use rustoleum on terracotta?
Place the terra cotta pots on the drop cloth and seal the inside and outside of each pot with a clear matt seal. Allow the paint to dry before you apply it. Using a thin coat of gloss exterior enamel spray paint (I used RUST-OLEUM American Accents) paint the outside and inside of the pots and saucers. Paint the exterior of your terracotta pot with a dark brown acrylic paint. This will give the pot a more rustic look.
I used a mixture of 2 parts acrylic to 1 part water. Apply the paint to both sides and let it dry completely. Once dry, apply a second coat and allow it to fully dry. Repeat this process for the other side.
If you want to add a little more color to your pot, you can add more water to the first coat, but be careful not to apply too much water as it will dry out your paint and you will have to reapply it. You can also use a paint brush to paint a small amount of paint on each side of a pot to give it a bit of color.
