You can read the resistance reading of your chainsaw in the user manual. If the reading is less than 1 ohm, then you have a bad coil. If the readings are greater than or equal to 1.5 ohs, the coils are good.
Table of Contents
How do I test a magneto coil with a multimeter?
Make sure the range of the multimeter is set to 40k without any auto-ranging by taking off the rubber shell. The multimeter probes should be placed at the magneto copper winding. The magneto is not functioning properly if the value is below 3k to 15k. If you are not sure what the value is, you can use the ohm meter to check it.
You can check this by putting a small amount of solder on the end of the wire that connects to the magnetic clip. When the solder is hot, the copper wire will glow red and you will be able to see the red wire in the picture below. This is an indication that you have a coil problem.
It is also a good idea to take a look at this picture to get an idea of what kind of coil is causing the problem: You can also check the resistance of your coil by placing a piece of wire on top of it and measuring its resistance. The resistance should be between 0.5 and 1.0 kOhms.
How many ohms Should a coil read?
You need to have a resistance reading of at least 3-4.5 ohms. A bad coil will show a higher reading. A little less is fine, but not too much. Next, connect the positive lead to ground, and the negative lead (the one with the black wire) to +5V.
If you are using a multimeter, you should be able to read the voltage between the two leads, but if you don’t have one, use a voltmeter to check it. The voltage should read between 3.3V and 4.2V, which is a good starting point. Now that you know how to measure the resistance of a coil, it’s time to get to work.
How do you check a coil in a magneto?
Touch one probe tip to the engine block and the other to the metal clip inside the rubber casing which normally attaches to the spark plug. Readings are given in a certain amount of ohms. A good reading can range from 3 k to 15 k.
A poor connection is indicated by a higher reading, while a good connection is indicated by a lower reading. If you are not sure which probe is which, you can use a multimeter to check the resistance of each probe. You can also use an ohmmeter to make sure that the correct resistance is being measured.
How do I know if my magneto is bad?
Someone needs to start the mower. If you don’t see a spark between the screwdriver and the engine, it’s not working. You can do this with a new battery, or you can use an old one that’s been sitting in the car for a long time. The old battery will last longer than the new one, and you won’t have to worry about replacing it every few years.
What is the resistance of a coil?
The resistance of the coil will be around 2,5 k ohms. F- coils have the same resistance. Z coils are no longer being used. The ground’s isolation resistance should be less than 0.1 ohms. The following table shows the resistance values for the different types of coils.
Why is there no spark on my chainsaw?
A spark plug might be defective and needs to be replaced. The spark plug on your chainsaw cannot create an electrical current to ignite the system. If the spark plug is dirty, cracked, eroded, or damaged, remove it and inspect it. If your spark plugs are not working properly, you may need to replace them. You can do this at home or at a local auto parts store.
