The lights should be supplied via 1.5mm2 three core steel-wire-armoured cable. Make sure that the cable is long enough to reach all the way to the ground and that you only fit lights that are suitable for outdoor use.
If you want to use LED lights, make sure they are not too bright, as they can cause eye strain and burn out your eyes. You should also ensure that they do not emit any harmful UV rays, which can damage the eyes and cause permanent damage to your skin.
Table of Contents
What cable do I need for LED lights?
A solid core 18-gauge wire is likely to be used for your lights. If you would like your wires to fit snug, 18-gauge is about as big as you can go, and the cost difference between this wire size and a much smaller cable is negligible. If you are going to use LEDs, you will want to make sure that you use a wire that is at least 1/2″ longer than the diameter of your LEDs.
This will ensure that the LEDs will be able to pass through the wire. If you do not have access to a longer wire, then you may need to cut the wires in half to get the length you need. You can also use wire cutters to do this, but be careful not to damage the LED wires.
What is the difference between 14 2 and 16 2 landscape wire?
If you want to make your own wire gauge, you can use a 1/4″ drill bit to drill a hole in the end of the wire, and then cut a piece of wire that is the same size as your gauge. This will give you the gauge you need for your project.
Do I need Armoured cable for outdoor lights?
Keeping the lights on requires the cable to be selected and installed correctly with a focus on protecting it both mechanically and electrical. It’s a requirement of the Wiring Regulations that any cable buried in the ground must have an earthed armour. In the case of a cable that is buried underground, it’s important to ensure that it is properly protected from the elements.
The cable should be buried as deep as possible to prevent it from being damaged by rain, snow, wind and other weather conditions. If you’re not sure how deep you should bury your cable, check with your local council to see if they have any guidelines on the subject.
Is flex cable suitable for outdoor use?
The rubber cable is waterproof and can cope with a range of temperatures from -20C to 60C, which is perfect for outdoor use. It also has a built-in power supply so you don’t have to worry about running out of power when you’re out and about.
What gauge wire is best for low voltage lighting?
It is recommended that you use 12-gauge or 10-gauge wire. This is to make sure the voltage doesn’t go down. If you are using a transformer that is not rated for the length of wire you will need to make sure that the wire is long enough to reach the end of the cable. For example, if you have a 10′ cable, you would need a wire of at least 12 gauge.
