If the torch is popping while you’re cutting, it may be because you’re holding the tip too close to the work and you’re limiting the gas flow. If the problem doesn’t go away, just back up the torch. If it doesn’t, you may need to adjust the length of your torch.
If you have a torch that has a built-in safety feature, such as a safety switch, make sure it’s turned on before you start cutting. This will prevent you from accidentally lighting yourself on fire.
Table of Contents
What causes welding backfire?
If a backfire occurs with high oxygen pressure and low fuel gas pressure, it is usually caused by holding the cutting torch too close to your work. Gas starvation of the cutting flame results in the flame being sucked into the piece of metal.
This happens when the torch is held too far away from the heat source, causing it to burn hotter than it should. If you see a flame coming out of your torch, it’s a good idea to turn it off and put it away for a while to cool it down.
How do you stop backfire in a gas cutting set?
Check that the regulators and nozzle size are suitable for the type of work. The correct working pressure for the equipment in use is set by the regulators. When the fuel gas is flowing through the system, keep the nozzle away from the pilot light, smouldering tow, or any other source of ignition.
If the regulator is not working properly, you may need to replace it with a new one. If you are not sure which regulator you need, check the manufacturer’s website for more information.
Do you turn on oxygen or acetylene first?
When using acetylene we recommend closing the oxygen valve first. Oxy-acetylene has a very low flame temperature and is not recommended to be used in an oxygen-vented system. Oxygen is a gas that is used to supply oxygen to the combustion chamber of a fuel-burning engine. It is also used as a propellant in a variety of other types of engines, such as jet engines and jet-propelled aircraft engines.
This process is called “oxidation” and the resulting water is known as “oxygen.” The amount of oxygen available for combustion varies depending on the type of fuel being burned. For example, gasoline contains about 1.5 to 2.0 percent oxygen, while diesel and kerosene contain about 5 to 10 percent.
What makes an acetylene torch pop?
If you want to turn your oxygen off, turn your acetylene off. Another problem could be holding the torch too close to a project. If you get too close, you get too much back pressure against the tip, and you’ll get a pop. It will blow a hole in your torch when it pops so hard.
What is flash back in gas cutting?
A flashback arrestor or flash arrestor is a gas safety device most commonly used in oxy-fuel welding and cutting to stop the flame or reverse flow of gas back up into the equipment or supply line. The equipment is protected from damage or fire.
Flash arrestors are designed to prevent the gas from escaping from the welding or cutting equipment. The gas can then be used to heat the weld or cut material, or to cool the cutting or welding equipment after it has been cut or welded.
What is blowback in welding?
Back blow occurs when welding toward the workpiece connection, or the end of a joint, or into a corner. When welding away from the connection or at the beginning of the joint, forward blow can be encountered.
Which two gasses have a slight tendency toward backfire and flashback?
Propylene is a very stable gas, with a slight tendency to backfire. Oxygen usage for a neutral flame is three to one. With its higher temperature secondary flame, propylene cuts faster than acetylene, and it produces less smoke.
