Flooring is typically installed in the same direction of your leading source of natural light, and the same goes for luxury vinyl. If you have large windows in a living room or entryway that allow a flood of natural light, then run your planks in that direction.
If you don’t have a large window in your home, you can still install flooring in this direction, but you’ll need to make sure that it’s not too high or too low.
For example, if you live in an apartment building and you want to install a floor that’s a few inches higher than the rest of the floor, it might be a good idea to put it on the ground floor.
Table of Contents
How long after laying vinyl can you walk on it?
It is recommended that you don’t walk on the seamed areas for a minimum of 24 hours after the vinyl floor is installed. The vinyl needs at least 2 days to cure after installation, so keep the room at a higher temperature.
Does the tongue or groove go against the wall?
The side that you want to place against the wall is the tongue. The groove is on the other side. If you are installing a tongue that is too large, you may need to cut it down to the correct size.
You can do this by measuring the length of your tongue and dividing it by two. For example, if you have a 12-inch tongue you would divide 12 by 2 to find out how many inches you need. Then you can cut that tongue to fit your wall perfectly.
Which way should tongue and groove flooring be started?
The floor has room to expand and contract if you leave a gap of about 12 inch. Pull the second piece toward you if you place the second board next to the first. Repeat steps 4 and 5 for the third and fourth boards. Continue this process until all four boards have been placed. Once all the boards are in place, place a piece of paper on top of each board.
This will act as a guide to help you position the pieces correctly. Take the paper and fold it in half lengthwise. Fold the folded paper into the shape of a triangle. Using a pencil, draw a line from the center of your triangle to a point on the other side. Use the pencil to trace this line. Draw a second line along the line you just traced.
Trace a third line down the middle of both lines. Cut out the triangles using a pair of scissors. Now that you have your triangles cut out, it’s time to glue them together. To do this, you will need to use a glue stick.
How do you find the straight line when installing laminate flooring?
Tie one end of a chalk line to one of the nails. The chalk line should run parallel to the wall. Paint the chalk lines on the wall with a paintbrush. If you are using acrylic paint, you will need to apply a thin layer of paint to the walls before you paint them. This will help prevent the paint from drying on your walls and will make it easier to remove later.
How do you stagger vinyl flooring?
After laying down the first plank, lay the next one and the next one until you cover the entire wall. If the last plank in the row is less than 6 inches, it is a good idea to cut off a bit of the first plank.
Where do you start laminate flooring in multiple rooms?
The sight line from the entry, except for hallways, makes it better to see the laminate flooring parallel to the longer walls. If you only have two rooms, you should install flooring in the direction of the shorter walls. If you have more than one room, you may want to consider installing a double wall.
This will give you more room to work with, but you will need to make sure that the double walls are not too close to each other and that they are spaced at least 6 feet apart.
Does the direction of flooring matter?
As a general rule, make sure to lay your floor in the same direction as the main light source in a room and in the same line as the most frequently used entrance.
If you have a lot of windows and doors in your room, you may want to consider using a curtain or curtain rod to block out the light. This will help to reduce the amount of light that hits your walls and ceiling.
You can also use a light switch to turn off the lights when you’re not using them.
