Drill a hole into the top corner of each end of the top landscape timber. The landscape timber spike is slightly larger than the drill bit. The spike connects the two timbers so they don’t fall apart. The top timber spikes should be cut to the same length as the spikes on the bottom timber, about 1/2″ to 3/4″ longer.
This will ensure that they will fit snugly in the holes drilled in each side. You will need to drill two holes for each spike, one at each corner. If you don’t, you will have to re-drill the hole to make sure they are all in place. Once you have drilled both holes, use a pair of pliers to tighten the ends of both spikes together.
Be careful not to over-tighten, as this will make it difficult to remove the spikes later on. After you tighten them, it is a good idea to sand down any rough edges that may have been left behind by the drill.
Table of Contents
What can I use to hold landscape timbers in place?
Rebar is the best way to suck up timbers. You can use it alone or in conjunction with landscape spikes and screws, but it’s best to use a combination of the two. If you’re looking for a way to add a bit of structure to your deck, you can also use rebar to build a deck out of 2x4s.
This is a great option if you don’t have a lot of space to work with, and you want to make sure that the deck is sturdy enough to support the weight of your boat. It’s also a good idea to keep in mind that you’ll need to drill a hole in the center of each 2×4 to allow for the screws to pass through.
Should you seal landscape timbers?
Most projects will require trimming of the wood before installation. The timber’s life and quality would be diminishing quickly if these ends were not sealed. It is important to seal and coat the exposed ends of pressure-treated lumber. The best way to do this is to use a wood sealer.
These products are available in a wide variety of strengths and colors, and can be applied directly to the surface of your wood. They are also easy to apply, requiring only a small amount of time and a few tools.
What size nails for landscape timbers?
Landscape timbers and other large items need to be secured. This is the most common size used for fence posts. It is also the size that is most commonly used in the construction of a fence post.
How long do landscaping timbers last?
I have used treated landscape timbers for 40 years and they usually last 15-20 years. projects. Many are rotting within a few years of installation. I am not sure if this is a problem with the wood itself or the way it is treated.
Rated 5 out of 5 by HomeDepotCustomer from This product is great. It is easy to use, and it works well. The only thing I would change is that it would be better if it came in a larger size. Otherwise, it’s a great product.
How far apart should landscape stakes be?
If you want your weed barrier to stay in place for a long time, don’t skimp on landscape staplers. If you plan to use the barrier, you should use a staple every 8 to 12 inches along all edges of the fabric. If you’re using a fabric barrier, you’ll want to make sure that it’s strong enough to hold up to the weight of your plants.
